Page 15
4. MOVING THE MACHINE
WARNING • This machine is fitted with castors to make it easier to move.
Take care when moving the machine on an inclined surface.
• The Header Assembly has a forward centre of gravity, so it
is important that at least two people are used to fit or remove
the Header Assembly.
• The fitting position of the Header Assembly is high, and it is
important that a means of reaching the height safely, without
stretching, is available. (e.g. steps, step stool etc.)
• The overall height of the machine, with Header assembly
fitted, is 2200mm, take care of any overhead obstructions
e.g. light fixtures.
5. INSTALLATION
Notes on Installation
WARNING • NEVER turn the power to the machine ON until installation
has been completed.
• In order to prevent possible electric shocks, be sure that the
machine is connected to the mains with a securely connected
earthed plug.
• So that customers are not injured by the movement of the
Ski Steps, ensure that there is at least 500mm separation
between other machines or walls.
CAUTION • In order to avoid damage to the machine due to mis-operation,
ensure that the voltage of the mains supply is 230volts AC.
NOTE • If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level adjusters
to prevent the machine sliding on the floor.
• In order to gain access to the Power Supply and CPU assemblies,
make sure that the rear of the machine is separated from a wall
or other machine by at least 500mm.
• When installation is complete, it is imperative that the game is
initialized. (See section 6-5 page 21)
Comments to this Manuals